Features
See allSurface preparation
• Remove all wax, oil and grease by solvent cleaning in accordance to guidelines given by SSPC-SP1.
• Dry brushing to remove soluble salts, dirt and dust.
• Freshwater jetting is required to remove all loose contaminants and soluble salt deposition.
• Remove scale by chipping, needle gun or spot blasting. Any loose or flaking coatings should be taken back to a firm edge.
• Mechanically clean the surface using hand or power tools to a minimum standard of St 2 (ISO 8501-1:1988) or SSPC-SP2 taking care to avoid polishing the surface. For optimum performance an abrasive blast to Sa 2 or SSPC SP-6 (commercial blast) is recommended with an average surface profile of 30 to 50 microns.
• Where necessary remove weld spatter and round off all rough weld seams and sharp edges to a smooth surface.
Application procedure
Stir contents of the can thoroughly before use. Thinning is not usually required. However, if thinning is desired, do not exceed the recommended thinning ratio.
Tools you can use
Available Packs
1 Coat
12Sqm/L @50 Microns**
Coverage
On well-prepared surfaces, as per the painting system recommended. Please refer to the Product Data Sheet for surface preparation and method of application.
** Actual coverage may vary from the quoted coverage due to factors such as method and condition of application, surface roughness, and porosity.
Other systems
we also recommend
-
Paint Doctor
-
Colour Guides
-
Make Your Plan
Let us design a project plan
to suit your needs.