Features
See allSurface preparation
Steel
- Remove all wax, oil and grease by solvent cleaning in accordance to the guidelines given by SSPC-SP1.
- Ensure that freshwater jetting is carried out to remove all loose contaminants and soluble salt deposition.
- Remove scales by chipping, with a needle gun or by spot blasting. Any loose or flaking coatings should be removed to create a firm edge.
- Mechanically clean the surface using hand or power tools to a minimum standard of St 2 (ISO 8501-1:1988) or SSPC-SP2, taking care to avoid polishing the surface.
- Where necessary, remove the weld spatter and round off all rough weld seams and sharp edges to create a smooth surface.
Concrete
• Ensure that the surface is sound. Remove laitence by thorough wire-brushing, acid etching or sweep blasting. Blowholes and other defects should be filled with Solventless Epoxy Filler.
Application procedure
Stir the contents of the can thoroughly before use. Thinning is not usually required. However, if thinning is desired, do not exceed the recommended thinning ratio.
Tools you can use
Available Packs
1 Coat
10 Sqm/ L @ 40 microns**
Coverage
On well-prepared surfaces, as per the painting system recommended. Please refer to the Product Data Sheet for surface preparation and method of application.
** Actual coverage may vary from the quoted coverage due to factors such as method and condition of application, surface roughness, and porosity.
-
Paint Doctor
-
Colour Guides
-
Make Your Plan
Let us design a project plan
to suit your needs.