Features
See allSurface preparation
New vessels
- Navilux 4100 must be applied to suitably primed substrates, e.g. with Epimastic 3000HS.
- The surface preparation of the substrate should be as per required for the primer, unless otherwise recommended by Berger Paints Representative.
- Ensure that the specified overcoating times in between coats have not been exceeded.
- Ensure that the surface to be over-coated is clean, dry, and free from dust, grease and oil, or any other surface contaminants.
Maintenance (Over existing rosin-based anti-fouling)
- High pressure water jet or power/hand tool clean to remove all accumulated fouling and the existing old anti-fouling coating.
- Allow to dry and ensure surface is thoroughly clean and existing paint system is tightly adherent before applying a tie-coat, e.g. Epimastic 3000HS.
- Then overcoat with 2 coats of Navilux 4100.
Application procedure
Stir contents of the can thoroughly before use. Thinning is not usually required. However, if thinning is desired, do not exceed the recommended thinning ratio.
Tools you can use
Available Packs
1 Coat
13.6 Sqm/L @ 50 Microns**
Coverage
On well-prepared surfaces, as per the painting system recommended. Please refer to the Product Data Sheet for surface preparation and method of application.
** Actual coverage may vary from the quoted coverage due to factors such as method and condition of application, surface roughness, and porosity.
Other systems
we also recommend
Navilux 4900
Navilux 4900
A single component, high solids chlorinated rubber based antifouling designed for tropical waters.
Conventional Anti - Fouling performanceTin-Free product
-
Paint Doctor
-
Colour Guides
-
Make Your Plan
Let us design a project plan
to suit your needs.